A device that measures the temperature and humidity in the air around it. It then displays the results on a small screen called an OLED display of 0.96 inch(128X64 pixels) for 2 seconds. It is ...
Programmed an ATmega2560 to interact with sensors to monitor the temperature and humidity. Then send a signal to the appropriate device (LEDs) to control the temperature and humidity.
The hardware setup shown below includes the Arduino Uno R4, a DHT11 sensor, and the built-in Wi-Fi for email alerts. The DHT11 is connected with VCC to 5V, GND to ground, and the data pin to Digital ...
Abstract: The aim of this work is the implementation of an intelligent controller based on fuzzy logic to provide an environment conducive to plant growth within the greenhouse, where the main ...
Arduino Nicla Sense Env is a new sensor module with temperature, humidity, and gas (TVOC, NO2, O3) sensing that follows the launch of the Arduino Nicla Sense ME (Motion & Environment) module over ...
Results that may be inaccessible to you are currently showing.
Hide inaccessible results