You will need a pull-up resistor of about 5 KOhm between the 1-Wire data line and your 5V power. If you are using the DS18B20, ground pins 1 and 3. The centre pin is the data line '1-wire'. We have ...

You will need a pull-up resistor of about 5 KOhm between the 1-Wire data line and your 5V power. If you are using the DS18B20, ground pins 1 and 3. The centre pin is the data line '1-wire'. This ...

The hardware setup shown below includes the Arduino Uno R4, a DHT11 sensor, and the built-in Wi-Fi for email alerts. The DHT11 is connected with VCC to 5V, GND to ground, and the data pin to Digital ...

How can you remotely control home heating? Here’s an SMS remote control system using the mobile network, featuring relay outputs and a temperature sensor. It’s based on an ATmega328P and the Arduino ...

[Jason] learned a lot by successfully automating this meat smoker. This is just the first step in [Jason’s] smoker project. He decided to begin by hacking a cheaper charcoal-fed unit first, before ...

The official Arduino team have this week announced the launch and availability of their new Arduino Edge Control board priced at $169 or $199. Designed to provide you with a remote monitoring and ...