You will need a pull-up resistor of about 5 KOhm between the 1-Wire data line and your 5V power. If you are using the DS18B20, ground pins 1 and 3. The centre pin is the data line '1-wire'. We have ...

You will need a pull-up resistor of about 5 KOhm between the 1-Wire data line and your 5V power. If you are using the DS18B20, ground pins 1 and 3. The centre pin is the data line '1-wire'. This ...

How can you remotely control home heating? Here’s an SMS remote control system using the mobile network, featuring relay outputs and a temperature sensor. It’s based on an ATmega328P and the Arduino ...

The hardware setup shown below includes the Arduino Uno R4, a DHT11 sensor, and the built-in Wi-Fi for email alerts. The DHT11 is connected with VCC to 5V, GND to ground, and the data pin to Digital ...

ESP-01 is a tiny and useful piece of hardware. It has a 32-bit MCU, 2.4GHz 802.11 b/g/n WiFi, 1MB flash memory, and several other useful embedded features. Such ...

[Jason] learned a lot by successfully automating this meat smoker. This is just the first step in [Jason’s] smoker project. He decided to begin by hacking a cheaper charcoal-fed unit first, before ...

The official Arduino team have this week announced the launch and availability of their new Arduino Edge Control board priced at $169 or $199. Designed to provide you with a remote monitoring and ...